Installation Instructions for Installing Kennel Panels to Existing Building

    Installing chain link kennel panels to existing buildings may be done by attaching the panels using 1 3/8 " tension bands and lag bolts for wood installations and concrete anchors for concrete or brick installations.

Step 1

  Attach 2 1-3/8" tension bands on to kennel frame on side to be attached to building or existing structure approximately 12" from the top and 12" from the bottom.  Each connection takes 2 tension bands.

Step 2

    Place panel next to building or existing structure and mark proper placement to drill for bolts or anchors.

Step 3

    Move panel to the side and drill pilot holes or applicable holes for either lag bolts or concrete anchors depending on job application.  *Note- Hoover Fence does not supply either lag bolts or concrete anchor bolts; these are easily found at your local hardware store.  The holes in the tension bands for such hardware are designed to fit 5/16" hardware.

Step 4

Replace panel in designated place along building or existing structure and attach.